Product ID:P-120, THORNEL PITCH & THERMALGRAPH BASED ON (SUPDAT)
MSDS Date:06/16/1997
FSC:9390
NIIN:00N085365
MSDS Number: CHBMR

AMOCO PERFORMANCE PRODUCTS INC

200 EAST RANDOLPH DRIVE
CHICAGO, IL 60601
US

Emergency Phone: 800-424-9300(CHEMTREC)

Info Phone: 312-856-3340;800-222-2448

Cage: 15958

AMOCO OIL CO

CHICAGO, IL 60601-6401 US

Telephone: 800 447-8735

Cage: 15958

CARBON; (CARBON FIBER, PITCH BASED)

CAS: 7440-44-0

RTECS: FF5250100

Fraction By Weight: 100%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 2 MG/M3 TDUST

ARE USED/HNDLD SHOULD BE PROPERLY PROTECTED AGAINST

RTECS: 9999999ZZ

INVOLVING CHRONIC APPLICATION OF PITCH

RTECS: 9999999ZZ

WEAK LOC TUMORIGENIC RESPONSE. BENZENE EXTRACT OF

RTECS: 9999999ZZ

GENETIC EFTS.

RTECS: 9999999ZZ

MEETS CRITERIA FOR BEING TOX, CORR,

RTECS: 9999999ZZ

SUBPART C). THIS MATL COULD ALSO BECOME HAZ WASTE IF

RTECS: 9999999ZZ

IF IT IS HAZ WASTE, REGS IN 40 CFR 262-266, 268, 270

RTECS: 9999999ZZ

FIBERS. NIOSH REC EXPOS LIM OF 3 FIBERS/CC FOR

RTECS: 9999999ZZ

RECS EXPOS GUIDELINE OF 3 FIBERS/CC UP TO 10

RTECS: 9999999ZZ

CONSERVATIVE APPROACH & INCLS ALL FIBER DIAMETERS IN

RTECS: 9999999ZZ

OUR MFG OPERATIONS HAVE BEEN LOW-TYPICALLY 0.01-0.02

RTECS: 9999999ZZ

CHOPPING OPERATIONS.

RTECS: 9999999ZZ

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:NO Skin:NO Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:THIS PROD HAS BEEN EVAL & DOES NOT REQ
ANY HAZ WARNING ON LBL UNDER OSHA CRITERIA. HNDLG &/OR PROCESSING
OF THIS MATL MAY GENERATE AIRBORNE FIBERS & PARTICLES WHICH CAN
CAUSE MECH IRRIT OF EYES, SKIN, NOSE & THROAT. EYE/SKIN CONT:NO
SIGNIFICANT HLTH HAZS IDENTIFIED. PARTICLES/FIBERS MAY CAUSE SLIGHT
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:NOT RELEVANT
Effects of Overexposure:HLTH HAZ:DISCOMFORT SIMILAR TO GETTING DUST IN
EYE/RUBBING SAND AGAINST SKIN. INHAL:NO SIGNIFICANT IRRIT EXPECTED
OTHER THAN POSS MECH IRRIT. INGEST:NO SIGNIFICANT HLTH HAZS
IDENTIFIED. TOX INFO:DENSE DUST GENERATED BY HNDLG &/OR PROCESSING
OF THIS MATL MAY BE IRRIT TO EYES, SKIN, NOSE & THROAT. STUDIES
(ING 3)
Medical Cond Aggravated by Exposure:NONE SPECIFIED BY MANUFACTURER.

First Aid:EYES:FLUSH W/PLENTY OF WATER FOR AT LEAST 15 MINUTES. GET
MEDICAL ATTENTION IF IRRITATION PERSISTS. SKIN:WASH EXPOSED SKIN
W/SOAP & WATER. INHAL:REMOVE TO UNCONTAMINATED AREA. GET MEDICAL
ATTENTION. I NGEST:IF LARGE AMOUNT IS SWALLOWED, GETMEDICAL
ATTENTION.

Extinguishing Media:AGENTS APPROVED FOR CLASS A HAZARDS (E.G., FOAM,
STEAM) OR WATER FOG.
Fire Fighting Procedures:USE NIOSH APPROVED SCBA & FULL PROTECTIVE
EQUIPMENT .
Unusual Fire/Explosion Hazard:FIBER, DUST & FIBROUS PARTICLES ARE
ELECTRICALLY CONDUCTIVE & CAN CAUSE SHORTING IN ELEC EQUIP. EXPLO
SHORTING OF HIGH VOLTAGE SYSTEMS IS POSS. CARBON (SUPDAT)

Spill Release Procedures:CONTAIN & REMOVE BY MECHANICAL MEANS. VACUUM
OR SWEEP OUT; AVOID PRODUCING DUST.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling and Storage Precautions:MINIMIZE DUST GENERATION &
ACCUMULATION. NO SPECIAL STORAGE REQUIREMENTS.
Other Precautions:NONE SPECIFIED BY MANUFACTURER.

Respiratory Protection:IF VENT IS INADEQ, USE NIOSH APPRVD RESP THAT
WILL PROT AGAINST DUST/MIST. CURRENTLY NO HLTH STDS EXIST FOR
EMPLOYEE EXPOS TO CARBON FIBERS. IN 1977, NIOSH PROPOSED THAT THEIR
REC STD FOR FIBROUS GLAS S BE APPLIED TO OTHER MAN-MADE (ING 9)
Ventilation:NO SPECIAL CONTROLS NECESSARY. LOCAL EXHAUST VENTILATION
MAY BE NECESSARY FOR SOME OPERATIONS.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:ANSI APPROVED CHEM WORKERS GOGGS .
Other Protective Equipment:ANSI APPRVD EYE WASH FOUNTAIN & DELUGE
SHOWER. LONG SLEEVE-GARMENTS W/TIGHT-FITTING CUFFS & USE OF
BARRIER(SUPDAT)
Work Hygienic Practices:NONE SPECIFIED BY MANUFACTURER.
Supplemental Safety and Health
MFR'S TRADE NAME/PART NO:HIGH & ULTRA-HIGH MODULUS FIBER. OTHER PROT
EQUIP:CREAMS/TALCUM PROVIDE ADDNL PROT TO SKIN. EXPLO HAZ:FIBERS
ARE ELECTRONICALLY CONDUCTIVE & MAY CAUSE SHORT CIRCUITS WHICH RSL
T IN DMG TO/MALFUNCTIONING ELEC EQUIP. ALL FORMS OF ELEC EQUIP,
ENCLOSURES & CIRCUITS IN/NEAR AREAS WHERE FIBERS (ING 2)

Melt/Freeze Pt:M.P/F.P Text:6512F,3600C
Solubility in Water:NEGLIGIBLE; <0.1%.
Appearance and Odor:BLACK CARBON FIBER, FABRIC OR CLOTH.

Stability Indicator/Materials to Avoid:YES
NONE IDENTIFIED.
Stability Condition to Avoid:AVOID GENERATING DUST.
Hazardous Decomposition Products:NONE IDENTIFIED.

Waste Disposal Methods:DISP MUST BE I/A/W APPLIC FED, STATE/LOC REGS.
DO NOT INCIN. BURIAL AT PERMITTED LANDFILL IS REC. RCRA:THIS UNUSED
MATL, WHEN DISCARDED/DISP OF, IS NOT SPECIFICALLY LISTED AS HAZ
WASTE IN FED REGS; HO WEVER, IT COULD BE CONSIDERED HAZ IF IT(ING
6)

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.